ALLOY600 is Ni-Cr-Fe alloy
- good resistance to oxidation, carburization and nitridation
- good resistance to stress corrosion cracking, at both room and elevated temperatures
- good resistance to dry chlorine and hydrogen chloride
- good mechanical properties at sub-zero, room and elevated temperatures
ALLOY600 is recommended for service above 700 C (1290 F) because of its higher creep-rupture properties, obtained via controlled carbon content and, except for strip products, coarse grain size.
Stock Form and Sizes
Round BarSpecification:ASTM B166/B564¦@ASME SB166/SB564¦@AMS5665(¬ªÌÝ)
NACE MR0175(ISO 15156) ¦B564/SB564 Apply to Forged Bar Only
¦@1000o@2000o@£3000o@¡3500o@4000o@2500o`3990o¦@Rolling Thread sizes available in C276(M4 to M10)
Hex BarSpecification: ASTM B166
Sourcable Ex-Stock Material for Other Forms from Japanese Distributor
Rod & Wire
¦@¢EEELimited Sizes Only@EEEPlease enquire
ALLOY600 is resistant to a wide range of corrosive media. Due to the chromium content the alloys possess better corrosion resistance than ALLOY200/201under oxidizing conditions.
At the same time, the high nickel content results in good corrosion resistance under reducing conditions and in alkaline solutions and leads to virtual immunity to chloride-ion stresscorrosion cracking.
ALLOY600 shows moderate resistance to mineral acids and good resistance to acetic, formic, stearic and other organic acids.
Excellent resistance is shown in high purity water, as used in the primary and secondary circuits of some nuclear reactors.
ALLOY600 is particularly resistant to attack by dry chlorine or hydrogen chloride, even at temperatures up to 650 C (1200 F).
At high temperatures in air the soft-annealed and solutionannealed alloys show good resistance to oxide scaling and have high strength.
The alloys also resist ammonia bearing atmospheres, as well as nitrogen and carburizing gases. Under alternating oxidizing and reducing conditions the the alloys may suffer from selective oxidation (green rot).
Typical applications are:
- thermocouple sheathing in aggresive atmospheres
- vinylchloride monomer production: resistance to chlorine,
hydrogen chloride, oxidation and carburization
- conversion of uranium oxide to hexafluoride: resistance to@attack by hydrogen fluoride
- production and use of caustic alkalis, particularly in the
presence of sulphur compounds
- production of titanium dioxide by the chlorine route
- production of organic and inorganic chlorinated and fluorinated compounds: resistance to attack by chlorine and fluorine
- nuclear reactor components
- heat treatment furnace retorts, furnace belts and components, particularly with carburizing or nitriding atmospheres
- catalyst regenerators in petrochemical production
Mechanical propertiesiRound Barj
|Condition||Yield Strength(Mpa)||Tensile Strength(Mpa)||Elongation(%)||Hardness(HB)|
|ASTM Min Value||Soft Annealed||205||550||30|
|Typical Values at RT||Hot Worked||431||706||38||180|
|Typical Values at RT||Cold Worked||706||882||20||235|
|Typical Values at RT||Soft Annealed||284||608||45||145|
International Specification Comparison chart
- All the information on this website is published in good faith and for general information purpose only and not for technical design purposes. We do not make any warranties about the completeness, reliability and accuracy of this information. Any action you take upon the information on our website is strictly at your own risk. and we will not be liable for any losses and damages in connection with the use of our website.